I have gone over the Flyer Splines documentation a whole number of times, yet i still am clueless as to how they work and how to set them up.

would i make a starting region, a path of nodes then what? I am totally confused.

Is there a certain way of doing them in a particular format or not? Thanks

A flyer spinepath is set up basically like you set up a spawnpath. It's a series of nodes. Everything else (like how you label them) should be pretty clear (or at least somewhat clear) in the flyer splines doc.

im kinda lost on that too the splines, if you set them up like a spawn path, just run along the ground and make my y-wing make a u turn and plow into the ground

So move the splines up and down by holding shift and moving the mouse.

ohh wow i knew i was missing something obvius but this is a new low even for me