Running speed

Fiodis · Post by **Fiodis** » Fri Jan 30, 2009 7:41 pm

Where in the ODF do you change running speed? I gave a saber to Boba Fett, and he runs really slow.... But sifting through the Aayla odf didn't seem to reveal anything about running.

Yodakid · Post by **Yodakid** » Fri Jan 30, 2009 7:50 pm

MaxSpeed = 8.0 \\whatever number you you want, That is the speed for the clone sharpshooter

MileHighGuy · Post by **MileHighGuy** » Fri Jan 30, 2009 7:51 pm

MaxSpeed = 8.0 // base forward speed
MaxStrafeSpeed = 6.0 // base right/left speed

Sky_216 · Post by **Sky_216** » Fri Jan 30, 2009 7:51 pm

Use these values:

Hidden/Spoiler:

MaxSpeed                = 7.0       // base forward speed

MaxStrafeSpeed          = 5.25       // base right/left speed

MaxTurnSpeed            = 5.0       // base turn speed

JumpHeight              = 1.78      // base jump height in meters

// Speed multipliers for various actions

JumpForwardSpeedFactor  = 1.3       // boost forward part of velocity by this factor when jumping

JumpStrafeSpeedFactor   = 1.0       // boost side/backward part of velocity by this factor when jumping

RollSpeedFactor         = 1.5       // in forward arc, boost speed by this factor when rolling

// Apparently contant for all or most classes:

Acceleration            = 70.0      // accelerate to full run in about 7/70 = 0.1 seconds

SprintAccelerateTime    = 0.35      // accelerate from run to sprint in this time

// ControlSpeed = "<stance> <thrustfactor> <strafefactor> <turnfactor>"

// For grounded states (stand, crouch, prone, sprint) and jet state,

//  in which the thrust/strafe stick controls the player's velocity,

//  these values are multipliers on the max speed and acceleration.

// For flying states (jump, roll, tumble), in which the thrust/strafe stick

//  applies an acceleration, these values only multiply the acceleration.

ControlSpeed            = "stand  1.00 1.00 1.00"

ControlSpeed            = "crouch 0.70 0.60 1.00"

ControlSpeed            = "prone  0.30 0.20 0.50"

ControlSpeed            = "sprint 1.50 0.50 0.35"

ControlSpeed            = "jet    0.30 0.30 1.00"

ControlSpeed            = "jump   0.03 0.03 0.35"

ControlSpeed            = "roll   0.02 0.02 0.35"

ControlSpeed            = "tumble 0.00 0.00 0.10"

Post by **Maveritchell** » Fri Jan 30, 2009 7:57 pm

Or you could just give him the classparent "com_jedi_default" instead of com_hero_default - which is, you'll notice, the real difference between non-Jedi and Jedi heroes. (You can also see all the movement values listed above in those .odfs, found in your sides/common and data/common/odfs folders.)

Running speed

Running speed

Re: Running speed

Re: Running speed

Re: Running speed

Re: Running speed