adding edge or subdividing
Posted: Fri Jul 03, 2015 9:43 pm
Anytime I add edge or subdivide and export a .msh and open it in .msh viewer it says outofbounce and overstack how can i fix it?
Page 1 of 1
Re: adding edge or subdividing
Posted: Fri Jul 03, 2015 11:55 pm
Are you freezing the model's operating stack before exporting?
Re: adding edge or subdividing
Posted: Sat Jul 04, 2015 12:11 am
no, can you show me the path I need in order to do it
Re: adding edge or subdividing
Posted: Sun Jul 05, 2015 8:56 pm
Re: adding edge or subdividing
Posted: Mon Jul 06, 2015 7:24 pm
my right tab does not have the edit tab it only has a select and transform tabs
Re: adding edge or subdividing
Posted: Mon Jul 06, 2015 8:32 pm
[color=#FF8040]xsidocs[/color] wrote:You can collapse a panel by right-clicking on its label. Right-click on the label a second time to expand a collapsed panel. This can be useful when working at small screen resolutions.
Re: adding edge or subdividing
Posted: Mon Jul 06, 2015 9:08 pm
Ok so the freezing model only works when in the the sub division panel I check the parallel edge loop and connect boxes, yet it doesnt work when I only click the connect box. why is that because i dont like the loop it makes, i only want one edge.
edit: so if i make one edge it fails yet if i loop it around it works. why?
edit: is there a subdivision shortcut key?
edit: so if i make one edge it fails yet if i loop it around it works. why?
edit: is there a subdivision shortcut key?