Page 1 of 1
AI dont follow a path
Posted: Sun May 02, 2010 1:44 pm
by 501st_commander
As i have been working on my project, i have noticed one major problem. The AI get stuck a tunnel entrance. They hardly ever follow the path that go through it.
Screen of the area:
(red they get stuck at, black they are not going though)
Please coment on how i can fix this.
thanks.
Re: AI dont follow a path
Posted: Sun May 02, 2010 2:12 pm
by Maveritchell
Better barrierwork.
Re: AI dont follow a path
Posted: Sun May 02, 2010 9:21 pm
by Caleb1117
Maveritchell wrote:Better barrierwork.
Correct.
Are you even using Barriers? Cause you pretty much have to use them in conjunction with planning for it to work.
If you already are using them, then try making the path through the tunnel a little thinner.
Re: AI dont follow a path
Posted: Sun May 02, 2010 9:47 pm
by 501st_commander
I am using them. I dont know if i am correctly, though.
Re: AI dont follow a path
Posted: Sun May 02, 2010 9:56 pm
by Maveritchell
501st_commander wrote:I am using them. I dont know if i am correctly, though.
For a really tight spot, run your barriers flush against the side of the path you want the AI to walk on.
Re: AI dont follow a path
Posted: Mon May 03, 2010 3:43 am
by SW_elite
Hmmmm.... I rekon thats it too, or id just make the path smaller.
Re: AI dont follow a path
Posted: Sun May 09, 2010 9:21 pm
by bonecrusher160
i make barriers but AI still run through them and jump of the cliff.
is there somthing to barriers besides placing them in zeroeditor???
Re: AI dont follow a path
Posted: Sun May 09, 2010 11:42 pm
by 501st_commander
is your map using the .bar file?