Page 1 of 1
XSI Problem URGENT
Posted: Fri Jan 05, 2007 1:15 pm
by MasterYoda91
I have Just downloaded the XSI6.0 Trial and have installed the plugin, however when i try to export a mesh nothing happens and a message appears in red saying "cannot create XSI2SceneExport3.XSIMeshExport3 error at line 81 of (filename for MSHExportScript) I go to the lne of the script and cant understand whats wrong. Pls Help. By the way I am using SWBF2.
I only have 29 days left of trial so help is required very urgently.
Posted: Fri Jan 05, 2007 1:31 pm
by Maveritchell
Did you install the addon?
Posted: Fri Jan 05, 2007 1:34 pm
by Dragonum
the pandemic addon dont work with XSI 6.0
i tested xsi 6 too and it wont work
Posted: Fri Jan 05, 2007 1:42 pm
by Maveritchell
Dragonum wrote:the pandemic addon dont work with XSI 6.0
i tested xsi 6 too and it wont work
Then I would assume it doesn't have a built-in mesh exporter, right? That's the problem.
Posted: Fri Jan 05, 2007 1:47 pm
by MasterYoda91
Where can i get an older version for free?
Posted: Fri Jan 05, 2007 3:01 pm
by Gogie
with the line 81 problem go into your user/SOftimager folder and then into the addons folder, run the exe file that says "RunMeOnce" in pandemic addon.
However with XSI 6.0 this only makes a much worst crash that is unsolvable, but it gets ridf of the red line that says "line 82"
you can get 5.0, 5.1 and 4.2 from softimage.com but 5.1 and 5.0 are trials and 4.2 is just a demo
Posted: Fri Jan 05, 2007 7:33 pm
by minilogoguy18
it doesnt work right with 6 because the original exporter was made for 4 >_>
Posted: Sat Jan 06, 2007 6:27 pm
by Qdin
Actually, I've just heard some news that apparently it doesn't work with v6 Foundations, but it works with Essentials (and therefore also Advanced)
so it's only the trial, apparently
