-= Gametoast.com =-

Hi received this error after adding another command post to my map, and it causes the AI on my map not spawn. Does anyone know how to solve this ?

Message Severity: 3
C:\Battlefront2\main\Battlefront2\Source\LuaHelper.cpp(312)
CallProc failed: (none):0: attempt to call method `Addcommandpost' (a nil value)

It seems like the stuff you wrote behind is invalid. May we see that part of the LUA?

i posted my whole LUA just in case

What did you do to add the fifth command post? What are all of the steps that you took in detail?

I used Fireflieks mooding guide and this was a piece i used:

In CaptureRegion, type cp5_capture. In SpawnPath, type cp5_spawn. Now, you must make the capture region for this new command post. Choose region from edit mode, and select New Group. Select cylinder. Now click near the command post. A huge cylinder will be over it. Select ‘select region’. Now, click the new region.



In the left palette, in region ID, it says region0. Change that to cp5_capture. Now, above, to the right, you will se another palette.



Change both of these to cp5_capture. Now, in height (back in the left panel), set X, Y, and Z to 5 each. Now, hold C and use the middle mouse button to lower it to go into the ground. Make sure it looks like this:

Now, you need to make the spawn path. Go to Path in edit mode. The left palette will look like this:



Press new path. A new path will come up in Path List, named Path 4. In Path Name, rename it cp5_spawn. Now, click about 6 or 7 times around your command post. Spheres will appear. This is the spawn path. Now, you have created another command post. There is only one step left to finishing the command post, which will be explained later, in Part 6. Now that you have made another neutral command post, you understand how to make command posts. One last thing about paths: to change their height, hold down shift and the right mouse button. This will allow you to slide the path up and down.
The next section will teach you to handle objects in Zeroeditor.

Zapattack1234 wrote:conquest:Addcommandpost(cp5)

Should be:

Is that what causes no AI to spawn on my map?

Did you make the correction and test it? Unless there are more errors you aren't showing us, then yes, this user error is the source. Did you get any munge errors? Munge errors should be corrected before playing your map.

The AI don't spawn because the map is broken.
The map is broken because of an incomplete munge.
The incomplete munge is the result of the typo.

Pay attention to everything you edit, don't make too many edits at once, test often.

I didn't test it because I'm not currently at home, but I will be back with the results tomorrow thanks for your help

You didn't follow-up on this thread but i'll assume its solved since this one is. When you create a 'help' thread please follow through to conclusion, this will help others as well.