-= Gametoast.com =-

I can use XSI now! (Kudos to Challenger33) But how would you smooth the edges on cubes? If you can? Just to make it look less cubic. I know I could make somewhat of a round cube from a sphere but smoothing the edges would just be easyer.


Thanks

Try using the bevel edges command. Hilite all the edges you want to bevel then choose the command. I believe it is in the modify polygon section of the menus. There also is a smooth command but that may do too much smoothing (will I think it does).

By way of example this took about 3 minutes total to do.
The stacked ones are beveled the single one is smoothed.