Spawn radius?

ARC_Commander · Post by **ARC_Commander** » Sun Apr 22, 2007 2:43 pm

I've put a command post high up on a bridge-y thing. I want units to spawn on top of the bridge, but they always spawn in mid-air. How can I change this?

phazon_elite · Post by **phazon_elite** » Sun Apr 22, 2007 3:11 pm

Just lower the spawn nodes.

Do that by selecting one and holding shift, then you can raise or lower it.

- EP-000782

trainmaster611 · Post by **trainmaster611** » Sun Apr 22, 2007 4:06 pm

But you can't move the spawn nodes if they are above the horizon (which depends on the Point-of-view you are looking at it in ZE). So if the sky horizon is below your spawn node from where you are looking at it, then you can't move it. This is very important

ARC_Commander · Post by **ARC_Commander** » Sun Apr 22, 2007 4:21 pm

No, I mean that they don't spawn anywhere on top of the bridge - rather, they spawn in mid-air over a massive canyon, then plummet to their death. Entertaining to watch, but not practical.

RC-1290 · Post by **RC-1290** » Sun Apr 22, 2007 4:29 pm

The nodes are the exact spawnplaces. So if they are positioned correct there is some other weird problem.

phazon_elite · Post by **phazon_elite** » Sun Apr 22, 2007 5:23 pm

trainmaster611 wrote:But you can't move the spawn nodes if they are above the horizon (which depends on the Point-of-view you are looking at it in ZE). So if the sky horizon is below your spawn node from where you are looking at it, then you can't move it. This is very important

I HATE when that happens. It's difficult to prevent, since you need certain angles when positioning a node.

- EP-000782

ARC_Commander · Post by **ARC_Commander** » Sun Apr 22, 2007 7:09 pm

When I select the CP in ZeroEditor, and press shift, nothing happens. What am I doing wrong?

phazon_elite · Post by **phazon_elite** » Sun Apr 22, 2007 7:10 pm

Not the cp, the spawn nodes.

- EP-000782

Post by **[RDH]Zerted** » Sun Apr 22, 2007 7:24 pm

ARC_Commander wrote:When I select the CP in ZeroEditor, and press shift, nothing happens. What am I doing wrong?

You haven't followed the Getting Started documentation. Read it and do it. It takes you through the process of editing and creating new CPs.

ARC_Commander · Post by **ARC_Commander** » Sun Apr 22, 2007 10:14 pm

Good idea, I'll try that!

SBF_Dann_Boeing · Post by **SBF_Dann_Boeing** » Sun Apr 22, 2007 10:50 pm

also if ur trying to move or select one of the default cps, u need to change into the conquest layer at the top in zeroedit.

ARC_Commander · Post by **ARC_Commander** » Mon Apr 23, 2007 6:19 pm

Yeah, I knew that much.

SBF_Dann_Boeing · Post by **SBF_Dann_Boeing** » Mon Apr 23, 2007 9:28 pm

just checkin

Spawn radius?

Spawn radius?

RE: Spawn radius?

RE: Spawn radius?

Re: RE: Spawn radius?