Page 1 of 1
How do I cut chambers in models! [Solved]
Posted: Sun Sep 30, 2007 6:29 am
by DarthD.U.C.K.
I want to make a hothhangar, and want to cut a model into a model(e.g. small chambers like
these on the right side)
ho i can do this?
Re: Need Help with models!
Posted: Sun Sep 30, 2007 6:16 pm
by Darth_Z13
Are you asking how to make a terrain cutter? Check out
this thread.
Cut chambers into a model
Posted: Sun Sep 30, 2007 8:29 pm
by AceMastermind
Terraincutters are for cutting through terrain, not models.
To make chambers in the model, you'll need to get the model into/or create the model in your 3d app and stencil the shape of the opening out with the knife tool, add edge tool or something similar and extrude the inner polygon outward. You could also boolean the wall with another object that is shaped however you want the opening to look, but if you use boolean then you should isolate the polygon that the operation will be performed on since it will save you time removing stray edges as a result of the boolean operation.