-= Gametoast.com =-

How exacly do you make the terrain so you can see and fall through it without the use of an terrain cutter .(ex. the shipped Mygeeto )

I'm pretty sure the ground on Mygeeto is just at like -100 height and covered by a layer of fog and props.

That's funny, cause when I move the texture brush and height brush over the fog props, it's ontop of the fog props. Hmm, Well, I'll just make the ground low and then raise it when I do planning edits.

I always thought it was like the tantive iv' where there is ground.

You can raise the fog like terrain in ZE. Maybe its in the Mygeto terrain file?