Page 1 of 1
Moving spawn paths up [Solved]
Posted: Sat Feb 10, 2007 8:02 pm
by trainmaster611
I'm making a space map and obviously you have to spawn in the capital ship...not the invsibile terrain in the middle of space
I've tried to move them with the C key but I can't.
I can rotate them though. So how would I change it?
Posted: Sat Feb 10, 2007 8:04 pm
by Clonedude55
OK pres and HOLD the c button then you click the left and/or right key and HOLD them to move them
Posted: Sat Feb 10, 2007 8:10 pm
by trainmaster611
Wow, you must think you're a genious or something
Posted: Sat Feb 10, 2007 8:11 pm
by Caleb1117
So you can rotate with X but cant do anything with C? are they like... atached to the cap ship model?
Admitedly I've not done a space map yet so probably can't help... but I shall try none the less.
Posted: Sat Feb 10, 2007 8:16 pm
by Clonedude55
trainmaster611 wrote:Wow, you must think you're a genious or something
Uhhhhhhhhhhh if you think I was bieng sarcastic or nything like that that is not right I was just trying to help
Posted: Sat Feb 10, 2007 8:26 pm
by Penguin
Ctrl: selects all nodes in the path
Shift: Raise or Lower that node/nodes
C: Left and right mouse click to move horisontally(sp?) node/nodes
X: Rotate the node/nodes
Sometimes nodes can be annoying and won't move, have to move the camera to the right angle to be able to move them right
Posted: Sun Feb 11, 2007 12:37 am
by trainmaster611
But I need to move mine UP ^^^^^^
Unfortunately, the advice you guys have given me only moves it sideways
[EDIT]: Wait, so your'e saying that holding shift and dragging the spawn point will move it up?
Posted: Sun Feb 11, 2007 12:45 am
by Penguin
Shift: Raise or Lower that node/nodes
Posted: Sun Feb 11, 2007 1:21 am
by FragMe!
A couple of tricks
For a whole path (useful if you want to move command post and the paths with it)
With a path selected but no nodes move the mouse over any line in the path until the whole path turn white.
Then right click you can move all the points at once. If you do the same thing but shift and right
click you can raise and lower them all at once.
For single nodes
put the mouse over the node you want to move left click will move it,
do the same thing to raise it but use left click and shift.
Important thing is for the camera to be in perspective mode it makes it a lot easier to grab the path and nodes.
Posted: Mon Feb 12, 2007 1:10 am
by trainmaster611
Thanks guys, I got it now
Posted: Mon Feb 12, 2007 8:01 am
by Teancum
trainmaster611 wrote:Wow, you must think you're a genious or something
Lose the smart attitude trainmaster. Now.