My most n00bish question

BF2-Master · Post by **BF2-Master** » Fri Apr 06, 2007 9:06 pm

How do I munge a side in Bf1???

BF2-Master · Post by **BF2-Master** » Sat Apr 07, 2007 12:26 am

It doesn't munge the new sides though!

Darth_Z13 · Post by **Darth_Z13** » Sat Apr 07, 2007 1:19 am

Maybe you forgot to make a folder for the sides in the _BUILD/SIDE folder? I don't know much about SWBF1 though...

BF2-Master · Post by **BF2-Master** » Sat Apr 07, 2007 2:04 am

Yes. I did everything in _build/side as well as in just side. Modified the files, then munged. But for some reason, it didn't munge.

Laserblast · Post by **Laserblast** » Sun Apr 08, 2007 11:43 am

I don't think BFBuilder ever compiled the sides for me. Therefore, I created a workaround. Not sure how well it works on other computers, though. In my case, I modified the REP side.

First, I created the folder in _build_pc (c:\lucasarts\bfbuilder\<modid>\_build_pc\sides\rep) and made sure the clean and munge from the example GAM side were in there. I moved munge_side and munge_fpm into there as well. Finally, I copied Levelpack, ConfigMunge, ModelMunge, OdfMunge, and TextureMunge into the folder as well.

I then went to that folder with the DOS prompt. From there I run munge_side. If the munge of this method doesn't work, you could try moving all the tools from the bin in.

It is probably better to try the other methods first. It has been a while since I set this up, and I am not sure these are all the steps I took.